Traxxas Nitro Exploded Views
Here we have listed all of the Traxxas nitro powered R/C exploded views. Please find the Traxxas model you are looking for parts for and click the name of the model. The link will take you to the Traxxas website where you can find all of the part numbers as well as save the PDF exploded view to your PC, phone or tablet!
Engines
Pro 1.5
High-Speed needle
TRX 2.5, TRX 2.5R, and TRX 3.3 Racing Engines:
A good starting point for the high-speed needle
is 3-3/4 to 4 turns out (counter-clockwise) from closed.
Notice the thin darker gray area between the low speed needle and the throttle arm. This is actually the other end of the slide valve from inside the carburetor. The low-speed needle is threaded into the slide valve and is set flush (even) with the edge of the slide valve.
Note: This is a good base setting. Adjustments may
need to be made to the low-speed needle for best
performance in your running conditions.
Idle Stop Screw
The idle stop screw controls the idle speed by preventing the carburetor slide from closing completely. Turn right (clockwise) to increase idle, and left (counter-clockwise) to decrease idle.
Idle Gap
A good starting point for the slide valve to stop at idle is a 0.7mm-1.0mm gap.
The carburetor is preset at the factory for break-in. The base setting should be right to start and run the engine through the break-in process. However, if you are having trouble getting the engine started or keeping it running, then you may need to readjust the fuel mixture to compensate for factors such as temperature, humidity, and altitude (air density). It is a good idea to bring the tuning card that was attached to the fuel tank with you.